آخر محتوى من قبل حامد الحلي العراقي

  1. ح

    طلب السلام عليكم أرجو مساعدتكم من لديه كتاب/ Fluid Power with Applications Seventh Edition Anthony Espos

    السلام عليكم أرجو مساعدتكم من لديه كتاب/ Fluid Power with Applications Seventh Edition Anthony Esposito يرسله لي على الإيميل: [email protected]
  2. ح

    Optimisation of a washing 4

    OPTIMISATION FORMULATIONS OF SUSPENSION DESIGN Given a dynamic system represented by the state space equation of x f"t\ x\ D#\ a general optimisation problem can be stated as follows 1] minimise F"D# "3a# subject to functional constraints gi "D#E9 i0\ 1\ [ [ [ \ m "3b# subject to design...
  3. ح

    Optimisation of a washing 3

    PHYSICAL AND DYNAMIC MODEL 1[0[ PHYSICAL MODEL Modeling and experimental validation of the washing machine suspension system dynamics considered in this research are discussed The actual suspension system that supports the tubdrummotor assembly of total mass M59[7 kg consists of four dry...
  4. ح

    Optimisation of a washing 2

    Modeling\ experimental validation and parameter optimisation constitute the three vital phases in the design of dynamic systems[ High cost of the design e}orts related to modeling and experimental validation of dynamic systems can be justi_ed if the implementation of an optimisation process...
  5. ح

    Optimisation of a washing

    In earlier publications\ the authors have presented modeling and experimental validation results of suspension dynamics of front load horizontal!axis washing machines[ In this paper\ various formulations for suspension design optimisation are discussed and implemented using grid and sequential...
  6. ح

    Presented solution can significantly improve learning experience of PLC programming

    Presented solution can significantly improve learning experience of PLC programming with minimal funds. Instead of building complex and expensive models, software simulation can and should be used. This approach has many pros and these are just some of them: • easier to develop, • cheaper to...
  7. ح

    Acquisition and Simulation of PLC Controlled Applications

    After programming the PLC, before starting a real process, the operator has to verify if the program is correct, i.e. if the PLC correctly performs the predefined control task. Therefore, the operator monitors the states at input and output port of the PLC. A usual way is to monitor all the...
  8. ح

    Development Environment for Monitoring,

    It is very important to monitor and test the operation of Programmable Logic Controller (PLC) in real time (online). There are many conventional, but expensive monitoring systems for PLC, such as Supervisory Control and Data Acquisition (SCADA) systems, software and hardware simulators (or...
  9. ح

    Design Considerations for Microcontroller

    This doc. describes the design considerations of microcontroller based process control for washing machine. In this paper, AT89S51 microcontroller is used to control the process of washing cycle and to drive the external output devices such as water inlet valve, wash motor, water drain valve...
أعلى